« previous next »
Pages: [1]   Go Down

Author Topic: Help with PoE controller buck topology  (Read 992 times)

0 Members and 1 Guest are viewing this topic.

Offline Cordoba_AKSTopic starter

  • Newbie
  • Posts: 2
  • Country: es
Help with PoE controller buck topology
« on: September 21, 2019, 10:24:06 am »
Hello everybody

I´m triying to make my project PoE
Logged
 

Online up8051

  • Frequent Contributor
  • **
  • Posts: 310
  • Country: pl
Re: Help with PoE controller buck topology
« Reply #1 on: September 21, 2019, 10:36:35 am »
And ?
Logged
 

Offline Cordoba_AKSTopic starter

  • Newbie
  • Posts: 2
  • Country: es
Re: Help with PoE controller buck topology
« Reply #2 on: September 21, 2019, 12:52:18 pm »
Sorry for that  :-\

I´m triying to make my project PoE powered with the SI3402B. I looked for schematics and i got one from an evaluation board.

When designing the PCB, should i place components on the output power traces in a linear order?

Can i just create a plane and attach all the components to it?

I mean in the picture attached there´s Vpos rail that ends in 5v. There aren´t any components in series on this rail. Can i connect every component to a VPos plane?

On the negative rail there are components in series so i must place some components like D1 before L1 and so on.
Logged
 
Pages: [1]   Go Up
« previous next »

Share me

Digg  Facebook  SlashDot  Delicious  Technorati  Twitter  Google  Yahoo
Smf

 


EEVblog Main Site EEVblog on Youtube EEVblog on Twitter EEVblog on Facebook EEVblog on Odysee