Latest update :-
"Hello All,
Sorry for the delayed update again, it’s been a very busy week here. We received new case models, and have been discussing slight changes now that we’ve actually been able to hold the new models with the new materials. We’re looking at ways to cut down the size a little and make it as comfortable to hold as possible. We are aiming to make it feel like you’re holding a point-and-shoot digital camera. We ordered a new reflow soldering oven for our new proto-boards, but unfortunately that oven was apparently damaged in shipping, so they’re sending us a new one which I hope will be here in the next few days. This board should hopefully be the last one that we use to tweak the system, and then we will be able to retool for the new case. These next few weeks are really looking like the end run for design. (At least that’s our hope, if everything comes together)."
So the ergonomics are their only problem at the moment, yet they still can't post a picture of it working. "retool for the new case" WTF! they've already shelled out for tooling and are now retooling?!?!?! Surely you 3D print the prototypes then only shell out for tooling once you've signed off on it. Then of course they still (if they're not lying through their teeth , which of course they are) There's still the slight issue of manufacture which they seem to think is going to be a walk in the park. What planet are these people on! Basically more bullshit delaying tactics, wonder how much longer they can string this out.