So I thought I already had my workplace filled to the max, but since I'm mister Tetris, I'm presenting proof that it's not so 😂 I needed to add a few newly made, a few repaired pieces and I still need to place a few currently being made and a few waiting to be repaired, e.g. HP RMS voltmeter 3400, VoltOhm meter and counter with nixie or buy an audioanalyzer
Added AT680 - LC / IR meter - bought, quadruple independent voltmeter - made by me, audio load 300W 2/4/8/16 Ohm (also made special compensated cables for connecting to the oscilloscope, when the output is switched to 1:10, the range on the oscilloscope is also switched automatically) - made by me, programmable counter - made by me, programmable VU meter with real dB display - bought, Tektronix oscilloscope 2465 4x300MHz - a gift from my son - a replacement for a stolen one. Under the workplace short-circuit protection module is a blank panel into which the connectors for the rear outputs of the device, central power supply 12V 2.5A for small measuring devices and fixtures will be fitted - made by me.
The biggest problem was finding a place for the oscilloscope, the printer moved out and I made an extendable and rotating structure in its place - under normal circumstances, the oscilloscope is on the side of the workplace, if necessary, it can be extended and turned so that it gets into the space between the monitor and the keyboard. There is a neon tube behind the monitor which illuminates the control panel of the oscilloscope during night work, the power of the tube is 4W. I haven't modified the cables yet, it will be disassembled and modified