deadlylover and 48 Guests are viewing this topic.
Bought a Cordless Bosch hot glue gun which arrived yesterday, this is a great unit and works so much better than my $7 ebay pos! it heats up 15 seconds instead of 5 minutes and charges from micro usb which is super handy!https://www.amazon.com.au/dp/B07J3F7ZWP/ref=cm_sw_r_cp_api_i_VlWLCbSE6HNKE
Quote from: djos on March 24, 2019, 04:11:46 amBought a Cordless Bosch hot glue gun which arrived yesterday, this is a great unit and works so much better than my $7 ebay pos! it heats up 15 seconds instead of 5 minutes and charges from micro usb which is super handy!https://www.amazon.com.au/dp/B07J3F7ZWP/ref=cm_sw_r_cp_api_i_VlWLCbSE6HNKENice, didn't know these were that much faster.Now I will wait till they equip it with the extra long tube for ultra precise dosing.Like this one :https://www.amazon.de/Bosch-Klebepistole-extralange-Düse-Volt
Yes the link should be fine now.
Looks good, I like the cordless better tho as the cable was always being in the way in my previous gun.
Quote from: djos on March 24, 2019, 10:14:51 amLooks good, I like the cordless better tho as the cable was always being in the way in my previous gun.Yes that is a big salespoint.But if I understand correctly it only heats up when you press the button, so it is not directly ready but you have 15 seconds?
+TiNIt looks like wavy-gravy power traces going from the heat sinks to the front. What the hell
Quote from: chickenHeadKnob on March 25, 2019, 06:31:10 pm+TiNIt looks like wavy-gravy power traces going from the heat sinks to the front. What the hellPower traces or nice smooth differential lines?Got to love the high speed acquisition porn!
I did a T shape engraving on a Toshiba flash chip with my new Cubiio toy laser.The left is a failed attempt with bad focus, and the right is a perfect T with crispy but slightly burned edge.The built-in rasterizer was way worse and it will guarantee to mess up some corners.The T shape shown here is based on my own rasterizer using only G01 X and G01 Y code.The firmware implementation of G02/G03/G01 X Y motion is flawed and is guaranteed not to work precisely with small feature sizes.
Quote from: gamalot on March 27, 2019, 12:32:37 pmYou shouldn’t burn an F word in Chinese, it’s very rude. Which?
You shouldn’t burn an F word in Chinese, it’s very rude.
After a few days of looking around and price negotiating:1. Keysight M9037A PXIe controller ( , $2k for a Haswell i7 computer)*12. Keysight M9243A 1GHz 2ch scope*2
Aliexpress birthday sales on now.A couple of these 555 based timer modules for 78c ea One of these flow sensors for a water pump dry run protection project.