This is a picture of my starting a prop that will contain the LM3914

[Shadetreeprops]

So since everyone has been so helpful in assisting me in finding the right stuff required to pull off my project, I thought it would be nice to share me fabing, and building the prop gun, before i start to place the electrical components inside it. I would like to thank everyone who helped me find the right stuff for this build.

This is the mock up, using 3/4" steel tube, and a broken stapler..



This is after some cutting, filing and, peice placements still got a ways to go but this is the up to date point



This is  a top view, the 9 holes is where the LED's will be going.




when i get it along further I will update it again. and Thank you all again.