WTB: Misc HP parts (one as seen on Daves video)

[Shock]

Daves recent video reminded me of a few parts I need.
Wanting to buy the following from a HP 3581a, HP 3580a or similar series gear.

1. A plastic sliding fuse door (see the below image and video at 5mins)
2. A metal stand (they all seem to be the same on this case).
3. A standard knob (as shown in the image)

Anyone got some of this stuff in their bits box or can pull off a wrecked unit?

[Shock]

bump

[Rory]

Good luck on the knobs. I managed to find a very nice fellow on the HP test equipment Yahoo group that came through with one for my HP6236B, but apparently that particular knob is rare these days. I still need another one to finish it.

[ConnorGames]

Could you have shapeways or similar 3d print a knob and fuse door?

[Rigby]

The knobs have metal innards for the set screw(s) to live in.  They can be 3D printed, but it would not be cheap, and they would need to be designed.

I'm looking for some HP knobs, too.  Buying non-working gear is less expensive than having them printed in small quantities.