« previous next »
Pages: [1]   Go Down

Author Topic: LFS: Fluke 27 range switch  (Read 698 times)

0 Members and 1 Guest are viewing this topic.

Offline kevbryTopic starter

  • Contributor
  • Posts: 19
  • Country: ca
LFS: Fluke 27 range switch
« on: January 26, 2021, 01:43:09 am »
Came upon a Fluke 27, but found that the top ring of range switch contacts have been destroyed. Any chance anyone out there has a dead meter I could scavenge a range switch from? Located in North America would be a bonus, Canada an extra bonus.
Logged
 

Offline Shock

  • Super Contributor
  • ***
  • Posts: 4275
  • Country: au
Re: LFS: Fluke 27 range switch
« Reply #1 on: January 27, 2021, 08:41:23 am »
Please set you forum profile to show your country
https://www.eevblog.com/forum/profile/?area=forumprofile
Logged
Soldering/Rework: Pace ADS200, Pace MBT350
Multimeters: Fluke 189, 87V, 117, 112   >>> WANTED STUFF <<<
Oszilloskopen: Lecroy 9314, Phillips PM3065, Tektronix 2215a, 314
 

Offline bd139

  • Super Contributor
  • ***
  • Posts: 23093
  • Country: gb
Re: LFS: Fluke 27 range switch
« Reply #2 on: January 27, 2021, 11:40:43 am »
Have seen this before. I had a 25 that some numpty soldered a wire across the fuse and then proceeded to do whatever blew up the fuse again. That managed to blow up the bottom range switch.

Rather than replace the switch I was given an entire new board assembly by another forum member. There are lots of beaten up units out there which have failed displays so it’s worth hunting around for one of those and just transplanting that.
Logged
 
Pages: [1]   Go Up
« previous next »

Share me

Digg  Facebook  SlashDot  Delicious  Technorati  Twitter  Google  Yahoo
Smf

 


EEVblog Main Site EEVblog on Youtube EEVblog on Twitter EEVblog on Facebook EEVblog on Odysee