Hi,
I have put a designed a version of the current source. I have the parts on order.
At this time the design is untested.LTspice ModelNormally, I would do some LTspice modelling. Unfortunately, there is no model for the LTC6655 reference chip, so I have gone straight to hardware.
Hardware DesignSchematic:
Board Design:
The board is designed to replace the lid on a Hammond 1591B box. I will make this board on my LPKF Protomat.
4-Wire ResistorThe sense resistor is a critical component in this circuit. I have designed the board to take a Vishay VPR221Z series part. These are expensive. So I have designed a work around for the prototype. I will epoxy this resistor to a heatsink:
I will keep the group informed with progress, good or bad.
Jay_Diddy_B