0 Members and 1 Guest are viewing this topic.
You mean nobody has a Dual-Z kit out for that model yet...? It's been out a while, hasn't it?
No, no synch belt...
Independent drive and leveling > sync belt. You do need three, though.
Quote from: Monkeh on November 14, 2020, 02:31:42 pmIndependent drive and leveling > sync belt. You do need three, though.I tend to agree
Quote from: Zucca on November 14, 2020, 03:24:53 pmQuote from: Monkeh on November 14, 2020, 02:31:42 pmIndependent drive and leveling > sync belt. You do need three, though.I tend to agreeWith 2mm pitch leadscrew, I'd agree. With the usual 8mm pitch, just one more assache to keep retuning over and over and over again. mnem
I am blown away...schematics, manual, top and bottom layer everything is super well documented and available hereBIGTREETECH finally someone in china is swimming upstream!
why don't you install a 0.2mm nozzle?Nice stuff btw.
[...] The fact that models have small defects when 3D printed is sometimes a good thing.